Digi TransPort WR11 User Manual page 723

Configuring system settings
CLI Pre-Login Banner
The router can display a banner before any login information is requested. The parameter
specifies the name of a file that is stored in the flash filing system and contains the text to be
displayed before the request for the username and password. This can be useful for displaying
a standard welcome message or any site-specific user instructions.
CLI Post-Login Banner
Once the user has successfully logged on to the router, a second message can be displayed.
This parameter specifies the name of a file containing the text to display. As above, the file may
contain site-specific instructions to be carried out once the user has logged in.
Allow CLI access from X.25 address n
Enables/disables logging into the router over an X.25 connection. The parameter n must be a
valid X.25 NUA (Network User Address).
With TRANSIP, use access level None, Low, Med, High, Super
Controls the security access level when using TRANSIP to access the router.
Default WEB page
Sets the default web interface page to open for the router. The default is default.asp.
Display runtime info on the login WEB page
Shows or hides runtime status information about the device on the login page.
TACACs+ authorises WEB requests on a page by page basis
If enabled, each request for a page results in a TACACS+ authorisation request getting sent off
to the TACACS server. The request will include the name of the requested page. If this setting
is disabled and you are using TACACS for authorization, a TACACS authorisation request is only
sent to the server when the user first logs in.
3. Click Apply.
Command line
Command
cmd
Digi TransPort® Routers User Guide
Instance Parameter
n tremto
Set web and command line interface options
Values Equivalent web parameter
0-86400 seconds Automatically log user out if
idle for h hrs m mins s
seconds
This CLI value is entered in
seconds only.
723