Digi TransPort WR11 User Manual page 424

Configuring DNS
Supply the IP address in the update
When enabled (the default), causes the router to supply the IP address as part of the dynamic DNS
update. When unchecked, the IP address is not supplied and the DYNDNS server attempts to
determine the correct IP address by other means (IP source address in update packet). Use this mode
if the router is behind a NAT router only.
Only send update when this router is the VRRP master
When enabled, causes the router to not send DDNS updates unless at least one Ethernet interface is a
VRRP master.
Enable debug
When enabled, enables debug tracing of the dynamic DNS transactions.
Command line
Command Instance
dyndns 0
dyndns 0
dyndns 0
dyndns 0
Digi TransPort® Routers User Guide
Parameter Values
updateint 0 -255
noip off, on
ifvrrpmaster off, on
debug off, on
Configure Dynamic DNS (DynDNS)
Equivalent web parameter
Update interval d days
Supply the IP address in the update
Only send update when this router is
the VRRP master
Enable debug
424