Digi TransPort WR11 User Manual page 219

Configuring network interfaces
4. To connect the Wi-Fi node to an existing Wi-Fi Access Point, click Network Scanning and click
Perform Network Scan. The router scans the local airwaves for any Access Points that are
present, and lists the results in a table:
Click Connect to connect to one of the Access Points.
5. Click Apply.
Command line
Basic Wi-Fi node settings
Command Instance
wifinode 0
wifinode 0
wifinode 0
wifinode 0
wifinode o
eth n
eth n
eth n
wifinode 0
wifinode 0
wifinode n
wifinode n
Digi TransPort® Routers User Guide
Parameter Values
enabled on, off
descr String
ssid String up to 32
characters
mode ap, client,
rogue
bridge_inst 0-3
bridge_inst 0-3
wificli on, off
wificli_add Integer
broadcastssid on, off
isolation on, off
roam_threshold RSSI value
roam_timeout Seconds
Configure Wi-Fi interfaces
Equivalent web parameter
Enable this Wi-Fi interface
Description
SSID
Mode
This Wi-Fi interface is a member of
Bridge instance n and therefore
bridged to the following interfaces
Interface
Link this Wi-Fi client interface with
Ethernet n
Link this Wi-Fi client interface with
Ethernet n
Hide SSID
Enable station isolation
None; command-line only
None; command-line only
219