Digi TransPort WR11 User Manual page 342

Configuring network interfaces
"route6" command
route6 print
The route6 command shows the IPv6 routing table.
Note Some of the displayed routes may point to unfamiliar interfaces. For example, the interface TCP
0 refers to the "loopback" interface. The routing table will contain entries that point to this interface
for any address that is owned by the device. NULL 0 refers to the "blackhole" interface. Packets that
are routed to this interface are dropped.
"ipv6 show" command
ipv6 show shows IPv6-related information.
i pv6 show <ent i t y> <i nst ance>
If entity and instance are omitted, shows information for all interfaces. Information displayed includes:
Information learned from RA messages, including routes, prefixes and DNS server addresses.
n
A list of multicast groups the interface is listening on.
n
A list of all learned DNS server addresses.
n
A list of all delegated prefixes learned from upstream routers.
n
All subnet prefixes assigned to LAN interfaces.
n
Digi TransPort® Routers User Guide
Configure IPv6 addressing support
342