Digi TransPort WR11 User Manual page 454

Configuring IP routing and forwarding
OSPF Configuration Filename
The file that contains the configuration data for OSPF is selected from this drop-down list. The
file should have a .conf extension.
Load Config file
When this button is clicked, the router attempts to load the file specified in the file selection list
box into the edit window below the button. The text in the window can be edited as required.
Save Config File
Saves the text in the edit window to the filename specified in the drop-down list above. These
three controls allow loading, editing, an saving an OSPF configuration file.
Restart OSPF after configuration file is saved
When enabled, restarts the OSPF functions once the edited configuration file has been saved.
Restart OSPF if a fatal error occurs
When enabled, restarts OSPF functioning after a delay of 5 seconds if a fatal error occurs.
OSPF Tracing
In common with some of the other functionality of the router, OSPF supports some debug
functionality. The amount of information in the debug traces is controlled from this drop-down
list. The available levels are Off, Low, Med, and High. Selecting Off disables debug tracing.
Ignore MTU indications
All OSPF routers must have the same Maximum Transmitted Unit (MTU) and this value is
advertised in the OSPF packets. When checked, the router ignores received packets that have
a MTU that differs from that of the router itself.
Use Interface IPsec source IP
When enabled, OSPF functions use the source IP address of the interface specified in
Configuration > Network > Interfaces > Advanced > PPP n: Use interface x,y for the
source IP address of IPsec packets on the interface being used. When unchecked, OSPF
uses the source IP address of the interface in use for its source address.
3. Click Apply.
Command line
Command Instance
ospf 0
ospf 0
Digi TransPort® Routers User Guide
Configure Open Shortest Path First (OSPF) parameters
Parameter
Enable
conffile
Values Equivalent web parameter
on,off Enable OSPF
filename OSPF Configuration
Filename
454