Digi TransPort WR11 User Manual page 913

Performing device administration tasks
Use USB devices with .all files
The following functionality is available from firmware version 4910 onwards.
A .all file is a special file that contains all of the firmware and configuration files in a single file that has
the file extension .all and is an exact copy of the TransPort router in its current state. This .all file can
then be applied to another TransPort router, as long as it is the same model.
1. To extract a .all file, use the Digi Flash Writer software.
2. Copy the extracted .all file to a USB storage device and insert the device into the TransPort
router.
3. Issue the command dir u: to confirm that the TransPort can access the USB device.
4. To copy the .all file onto the TransPort router, from the command line enter this copy
command:
copy u: m r 4110. al l t . al l
Replace mr4110.all with the correct .all file name. The t.all destination name can be any
destination. The source file (in this example, mr4110.all) must adhere to the 8.3 filename
convention, owing to limits of the FAT file system, or the process will fail.
Digi TransPort® Routers User Guide
Manage files
913