Digi TransPort WR11 User Manual page 505

Configuring Virtual Private Networking (VPN)
Both removes IPSec SAs when their IKE SA is deleted, and deletes IKE SAs when their
n
IPSec SAs are removed.
3. Click Apply.
Command line
Command Instance Parameter
ike n
ike n
ike n
ike n
ike n
ike n
ike n
ike n
ike n
ike n
IKE Responder command
É
Web
1. Go to Configuration > Network > Virtual Private Networking (VPN) > IPsec > IKE > IKE
Responder.
The IKE Responder page displays the various parameters for IKE 0 in Responder mode.
Digi TransPort® Routers User Guide
Values
retranint 0-255
retran 0-9
inactto 0-255
dpd on, off
natt on, off
initialcontact on, off
keepph1 on, off
privrsakey Filename
delmode 0=Normal
1=Remove IKE SA when
last IPsec SA removed
2=Remove IPsec SAs
when IKE SA remove
3=Both
openswan on, off
Configure Internet Protocol security (IPsec)
Equivalent web parameter
Retransmit a frame if no response
after n seconds
Stop IKE negotiation after n
retransmissions
Stop IKE negotiation if no packet
received for n seconds
Enable Dead Peer Detection
Enable NAT-Traversal
Send INITIAL-CONTACT
notifications
Retain phase 1 SA after failed
phase 2 negotiation
RSA private key file
SA Removal Mode
None. This enables support for
Openswan IKE implementations.
505