Enable Command Filtering - Digi TransPort WR11 User Manual

Configuring security
2. In the Command field, enter the desired command to filter on into the text box and click Add.
3. Once a command is added, you can remove it from the command filtering table by clicking
Delete next to the command.
4. When you have entered all the commands on which you want to filter, click Apply .
Command line
Command Instance Parameter Values
cfilter n
cmd n
cmd n

Enable command filtering

To enable command filtering from the command line for any particular instance of the command
interpreter, use the following command:
cm d <n> cf i l t on 1
The default action is to respond with the OK response. If the response needed is ERROR, use the
parameter:
cm d <n> cf i l t er r 1
Where n is the instance number.
Note Enclose any blank characters by double quotation marks. When substituting a command, upper
case characters are considered the same as the corresponding lowercase characters.
Digi TransPort® Routers User Guide
cmd Valid command line command
cfilton 0, 1
0=Off
1=On
cfilterr 0, 1
0=Off-OK
1=On-ERROR
Use command filtering
Equivalent web parameter
Command
n/a
n/a
811