Digi TransPort WR11 User Manual page 189

Configuring network interfaces
Send n byte pings to IP host a.b.c.d every h hrs m mins s seconds
For this setting, n specifies the payload size of a ping packet when using the auto ping feature.
Leaving this parameter blank uses the default value. The address a.b.c.d specifies the
destination IP address for auto-ping ICMP echo request. The values h, m and s specifies how
often the router transmits Auto-ping packets to the specified destination in (h) Hours, (m)
Minutes and (s) Seconds.
Switch to sending pings to IP host a.b.c.d after n failures
For this setting, a.b.c.d specifies an alternative destination IP address for the auto-ping ICMP
echo request to be sent to, should the main IP address specified in the parameter above fail to
respond. This allows the router to double check there is a problem with the connection and not
just with the remote device not responding. The value n specifies the number of pings that
must fail before the checking the second IP address. The extra IP address check is only
enabled if this parameter is set to something other than 0.
Only send Pings when this Ethernet interface is "In Service"
If this parameter is enabled, this interface sends ICMP echo requests when it is in service only.
The default setting is disabled; ICMP echo requests are sent when the interface is in service
and out of service.
Take this interface "Out of Service" after receiving no responses for s seconds
The length of time, in seconds, before a route will be designated as being out of service if there
has been no response to ANY of the ICMP echo requests during that time period.
Keep this interface out of service for s seconds
The length of time, in seconds, for which any routes using this Ethernet interface are held out
of service after a ping failure is detected.
3. Click Apply.
Command line
Command Instance
n/a n/a
n/a n/a
Digi TransPort® Routers User Guide
Parameter Values
ethvlan n/a
ethhub n/a
Configure Ethernet interfaces
Equivalent web parameter
Switch to Port Isolate Mode
Switch to Hub Mode
189