Digi TransPort WR11 User Manual page 312

Configuring network interfaces
Note When the serial port is not in 8-bit parity mode (such as it is in either 8-bit no parity, or 7-
bit with parity), the router will continually check for parity when receiving AT commands and
adjust and match accordingly.
Flow Control
The router supports software flow control using XON/XOFF characters and hardware flow
control using the RS232 RTS and CTS signals. Use this drop-down list to select Software,
Hardware or a combination of Both. To disable flow control, select the None option.
Enable echo on this interface
When enabled, enables command echo when using the command line interpreter. Disable this
setting if the attached terminal provides local echo.
CLI result codes
The required level of verbosity for command result codes. The available options are:
Verbose
n
Numeric
n
None
n
3. Click Apply.
Command line
Command Instance Parameter Values
asy n/a
S31=n n/a
S23=n n/a
&Kn n/a
Digi TransPort® Routers User Guide
descr Free text-description of
interface
n/a Where n=
3=115200
4=57600
5=38400
6=19200
7=9600
8=4800
n/a Where n=
0=None
1=Odd
2=Even
5=8 Data Odd
6=8 Data Even
Default 0
n/a Where n =
0=None
1=Hardware
2=Software
3=Both
Configure serial interfaces
Equivalent web parameter
Description
Baud rate
Data Bits / Parity
Flow Control
312