Digi TransPort WR11 User Manual page 445

Configuring IP routing and forwarding
Only queue one packet whilst waiting for the interface to connect
When enabled, the router enqueues only one packet while waiting for the interface to connect. When
unchecked, the router enqueues two packets.
When this route becomes available, deactivate the following interfaces x,y x,y
The interfaces specified by the values in these two pairs of drop-down list and text boxes will be
deactivated when this route becomes available again after being out of service. The router typically
uses this feature to deactivate backup interfaces when the primary interface becomes available after
being out of service. Select the required interface from the drop-down list and enter the interface
instance number into the text box as usual.
When this route becomes unavailable, remove the "Out Of Service" state on x,y
The interface and instance that should be taken out of the Out of Service state when the interface
that this route is configured to use is deactivated. Available interface options are None, PPP,
Ethernet, and Tunnel.
Keep this route in service for s seconds after OOS state is cleared
When enabled, the following text box is enabled (such as it is no longer disabled out), allowing a value
to be entered. The value specifies the period that the interface specified above will remain in service
even though it is actually unable to pass traffic immediately. This is behavior useful in situations where
a PPP interface is activating and traffic should not try the next interface until this one has been
allowed a certain amount of time to come up. When this timer expires, if the interface is unable to
pass traffic, it is marked Out of Service and the next interface is tried.
Assign this route to recovery group n
Used to assign the route to a recovery group. This means that if all the routes in a particular recovery
group go out of service, the out of service status is cleared for all routes in that group. If one route in a
group comes back into service, all routes with a lower-priority (metric) also have their Out of Service
status cleared.
Command line
Command Instance Parameter Values
def_route n
def_route n
def_route n
def_route n
def_route n
Digi TransPort® Routers User Guide
metric 0-
2147483647
srcip Valid IP
address
a.b.c.d
srcmask Valid
netmask
a.b.c.d
inrip on,off
doinact2 on,off
Configure default IP routes
Equivalent web parameter
Use metric n when the interface is not active
IP Address a.b.c.d
Mask a.b.c.d
Include this route in RIP advertisements
Make PPP n interface use the alternative idle
timeout when this route becomes available
445