Digi TransPort WR11 User Manual page 220

Configuring network interfaces
Note The roam_threshold and roam_timeout parameters can impact monitoring. If roam_threshold
and roam_timeout are both non-zero, and the Wi-Fi node is configured in client mode, monitoring of
the signal strength of the link to the currently associated Access Point starts as soon as the client has
successfully connected to that Access Point. Signal strength monitoring stops at any time the client
disconnects from the Access Point. If the RSSI of frames received from the Access Point stays below
the roam_threshold for roam_timeout consecutive seconds, monitoring stops and the client starts
scanning for Access Points.
Wi-Fi node security settings
Command Instance
wifinode 0
wifinode 0
wifinode 0
wifinode 0
wifinode 0
wifinode 0
radcli n*
radcli n*
radcli n*
* The Wi-Fi interfaces each use a fixed RADIUS client. For example:
Wi-Fi 0 uses radcli 1
n
Wi-Fi 1 uses radcli 2
n
Wi-Fi 2 uses radcli 3, and so on.
n
The following table details the authentication and encryption algorithms and the CLI commands
needed to configure them.
Network Authentication
Open
Shared
Digi TransPort® Routers User Guide
Parameter Values
security none
wep
wpapsk
wpa2psk
wparadius
wpa2radius
weptype open,
sharedkey
wepkeylen 64, 128
wepkeyindex 1-4
wpatype tkip, aes
sharedkey text
nasid String
server IP Address
password String
Data Encryption
Disabled
Disabled
Configure Wi-Fi interfaces
Equivalent web parameter
Use the following security on this
Wi-Fi interface
Not available on the WEB.
WEP Key size
WEP Key index
WPA Encryption
WEP Key/WPA pre-shared key
RADIUS NAS ID
RADIUS Server IP Address
RADIUS Server Password
CLI Commands
wifinode 0 security none
Not supported
220