Digi TransPort WR11 User Manual page 197

Configuring network interfaces
Reset probe failure count after n probe successes
The number of consecutive successful probes required before the current failure count is reset
to 0.
Use interface x,y over which to send probe
Overrides the routing code and forces the probe packets to be sent out of a specific interface.
Get the source IP address from interface x,y
Enables probe packets having the source IP address from a specific interface, rather than the
interface over which it is being transmitted.
3. Click Apply.
Command line
Command Instance
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
Digi TransPort® Routers User Guide
Parameter Values
vrrpid 0-255
vrrpprio 0-255
vboostprio 0-255
vboostsecs Integer
vprobemode off, TCP, ICMP
vprobeip IP Address
vprobeport 0-65535
vprobebackint 0-32767
vprobemastint 0-32767
vprobeadj 0-255
vprobeadjup 0=down
1=up
vprobefailcnt 0-255
Configure Ethernet interfaces
Equivalent web parameter
VRRP Group ID
VRRP Priority
Boost the priority by n for s
seconds after switching to the
MASTER state
Boost the priority by n for s
seconds after switching to the
MASTER state
Send p probe to IP address
a.b.c.d TCP port n
Send p probe to IP address
a.b.c.d TCP port n
Send p probe to IP address
a.b.c.d TCP port n
every n seconds when in
Backup state
every n seconds when in Master
state
Adjust priority n dir after x
probe failures
Adjust priority n dir after x
probe failures
Adjust priority n dir after x
probe failures
197