Digi TransPort WR11 User Manual page 330

Configuring network interfaces
Connect to host a.b.c.d Port n
The IP address or hostname and TCP port that the router should use when making a device
initiated connection.
Allow s seconds between connection attempts
The interval, in seconds, between device initiated connection attempts.
Send TCP Keep-Alives every s seconds
The interval at which TCP Keep-Alives are sent over the RealPort connection. A value of 0
means that Keep-Alives are not sent.
Send RealPort Keep-Alives every s seconds
The interval at which RealPort Keep-Alives are sent over the RealPort connection. A value of 0
means that Keep-Alives are not sent.
Enable exclusive mode
Enables exclusive mode. Exclusive mode allows a single connection from any one RealPort
client ID to be connected only. If this setting is enabled and a subsequent connection occurs
that has the same source IP as an existing connection, the old existing connection is forcibly
reset under the assumption that it is stale.
Enable authentication
Enables RealPort authentication.
Authentication secret
Configures the RealPort authentication secret.
3. Click Apply.
Command line
Command Instance
rport 0
rport 0
rport 0
rport 0
rport 0
rport 0
rport 0
rport 0
Digi TransPort® Routers User Guide
Parameter Values
enabled off, on
ipport 0-65535
maxnbsocks 0-255
encryption off, on
encport 0-65535
maxnbencsocks 0-255
initiate off, on
IPaddr Valid IP address
a.b.c.d
Configure serial interfaces
Equivalent web parameter
Enable RealPort
Listen on port n
Maximum number of sockets
Enable encrypted RealPort
Encryption mode to listen on
port
Maximum number of encryption
sockets
Enable Device Initiated RealPort
Connect to host a.b.c.d Port n
330