Digi TransPort WR11 User Manual page 190

Configuring network interfaces
Command Instance
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
Digi TransPort® Routers User Guide
Parameter Values
group 0-3,255
metric 1-16
mtu 64-1500
auton 0, 1
speed 0, 10, 100
duplex 0, 1, 2
maxkbps value in kbps
maxtkbps value in kbps
tcptxbuf value in bytes
linkdeact 0-86400
do_nat 0, 1, 2
ipsec 0, 1
ipsecent blank, eth, ppp
ipsecadd 0-255
firewall 0, 1
block_dns on, off
dmnr_reg on, off
nocfg 0, 1, 2, 3
Configure Ethernet interfaces
Equivalent web parameter
Ethernet Hub group
Metric
MTU
Enable auto-negotiation
Speed
0=Auto
10=10-BaseT
100=100-BaseT
Duplex
0=Auto
1=Full
2=Half
Max Rx rate
Max Tx rate
TCP transmit buffer size
Take this interface out of service after n
seconds when the link is lost
Enable NAT on this interface
0=Disabled
1=IP address
2=IP address and Port
Enable IPsec on this interface
Use interface x,y for the source IP
address of IPsec packets
x=Interface type
Use interface x,y for the source IP
address of IPsec packets
y=interface number
Enable the firewall on this interface
Enable DNS inbound blocking
Enable DMNR advertisement from this
subnet
Remote management access
0=No restrictions
1=Disable management
2=Disable return RST
3=Disable management and return RST
190