Digi TransPort WR11 User Manual page 482

Configuring Virtual Private Networking (VPN)
remote TCP/UDP port n
Allow IP packets with matching destination TCP/UDP ports to be tunneled.
local TCP/UDP port in the range of n1 to n2
Allow IP packets with source TCP/UDP ports in the specified range to be tunneled. This is only
available when IKEv2 is in use.
remote TCP/UDP port in the range of n1 to n2
Allow IP packets with destination TCP/UDP ports in the specified range to be tunneled. This is
only available when IKEv2 is in use.
5. Click Apply.
Command line
Set basic IPsec tunnel parameters
Command Instance Parameter Values
eroute n
eroute n
eroute n
eroute n
eroute n
eroute n
eroute n
eroute n
eroute n
eroute n
eroute n
eroute n
eroute n
eroute n
Digi TransPort® Routers User Guide
descr String
peerip IP address or hostname
bakpeerip IP address or hostname
locip IP address
locmsk IP Mask
locipifent blank, ETH, PPP
locipifadd Integer
remip IP address
remmsk IP Mask
remnetid String
authmeth Off, Preshared,
xauthinitpre, rsa,
xauthinitrsa
ourid String
ouridtype 0=IKE ID
1=FQDN
2=User FQDN
3=IPv4 Address
peerid String
Configure Internet Protocol security (IPsec)
Equivalent web parameter
Description
The IP address or hostname of
the remote unit.
Use n as a backup unit.
IP Address (for Local LAN)
IP Mask (for Local LAN)
Use interface x,y
x=Interface type
Use interface x,y
y=interface number
IP Address (for Remote LAN).
IP Mask (for Remote LAN).
Remote Subnet ID.
Use the following security on this
tunnel.
Our ID.
Our ID type.
Remote ID.
482