Digi TransPort WR11 User Manual page 169

Using the command-line interface
m i b- 2. syst em . sysdescr =
Sof t war e Bui l d Ver 5121.
at\smib=mib-2.system.sysobjectid: Show network management subsystem identification
The authoritative identification of the network management subsystem. TransPort does not support
outputting OID variables. Instead, oid is output.
m i b- 2. syst em . sysobj ect i d = oi d
at\smib=mib-2.system.sysuptime: Show system uptime
Shows the time the router has been running in 10-millisecond units (hundredths of a second).
m i b- 2. syst em . sysupt i m e = 1806718
The above example shows that the router has been running for 5 hours, 1 minute and 7.18 seconds.
at\smib=mib-2.system.syscontact: Show contact information
Shows a description of the contact person for the router. For TransPort, this is always a zero-length
string.
at\smib=mib-2.system.sysname: Show router name
Shows the name of the router. This is the name set in the Router Identity parameter on the
Configuration > System > Device Identity page.
m i b- 2. sys t em . s y s nam e = di gi . r out er
at\smib=mib-2.system.syslocation: Show router location
Shows the physical location of the router. For TransPort, this is always a zero-length string.
at\smib=mib-2.system.sysservices: Show router network layer services
Shows a value that represents the set of services the router provides. For each OSI layer, the router
provides services for, 2(L-1) is added to the value, where L is the layer. The layers are shown below.
For TransPort, this value is always 7 (Physical layer (21-1)+Data Link layer (22-1)+Network layer (23-
1)).
Layer
1
2
3
4
5
6
7
Commands for displaying interface information
The Interfaces hierarchy consists of the ifnumber variable and the iftable node:
Digi TransPort® Routers User Guide
Jan 31 2011 12: 26: 04
Functionality
Physical
Data Link
Network
Transport
Session
Presentation
Application
9W
AT commands
169