Digi TransPort WR11 User Manual page 595

Configuring legacy protocols
Use interface for source IP address
Setting this parameter to a PPP or ETH instance causes the source address for this SNAIP
instance to match that of the Ethernet or PPP interface specified.
Close TCP connection if it is idle for x secs
The maximum period of inactivity (in seconds) that may occur before an open TCP/ IP socket is
closed. The default value is 300 seconds (5 minutes). Normally it is not necessary to change this
parameter.
DLSw Ver
The DLSw version to use. Set to 0 (default) for version 1, set to 2 for version 2.
DLSw Role
When this parameter is set to Active, and the router is in SNA mode, this DLSw switch actively
connects to the remote DLSw switch.
DLSw Window
The DLSw window size. The value range is from 10 to 100. The default is 20.
UDP Capable
Controls the UDP transmission of DLSw SSP packets. Reception is always enabled for version 2
support. If set to OFF, the state transitions occur like DLSw version 1, but the router indicates
it is version 2-capable.
Use 1 socket
When this parameter is set to On, the router uses only one socket for both read and write
data. This is useful if the router is behind a NAT box and incoming connections are not possible.
This parameter can also be set to Compatible, in which mode both sockets are open to start
with and then after a negotiation one of the sockets is dropped.
Include MAC Exclusivity Capability
On or Off. Set this parameter to On to include the MAC exclusivity value in the capabilities
exchange message.
MAC Exclusivity Value
See above.
Ignore unsolicited response frames
When enabled, the router ignores unsolicited response frames.
Wait for Contact before progressing to CONNECT PENDING state
During the DLSw negotiation phase and when XID messages are being exchanged, this
parameter controls which end sends the CONTACT message. Normally this would be off in
which case this router would send the CONTACT message, but if this parameter is set, we
Digi TransPort® Routers User Guide
Configure Systems Network Architecture over IP (SNAIP)
595