Configuring Virtual Private Networking (VPN)
Forward debug to port
When enabled, the IKE debug is sent to debug serial port.
3. Click Apply.
Command line
Command Instance Parameter Values
ike
0
ike
0
ike
0
Configure IKE n parameters
É
Web
1. Go to Configuration > Network > Virtual Private Networking (VPN) > IPsec > IKE n.
2. Configure the parameters for the IKE instance:
Use the following settings for negotiation
The IKE negotiation settings.
Encryption
The encryption algorithm. The options are:
None
n
DES
n
3DES
n
AES (128 bit keys)
n
AES (192 bit keys)
n
AES (256 bit keys)
n
Digi TransPort® Routers User Guide
deblevel
0=Off
1=Low
2=Medium
3=High
4=Very High
ipaddfilt
Comma-separated list of IP
addresses
debug
on, off
Configure Internet Protocol security (IPsec)
Equivalent web
parameter
Debug Level
Debug IP Address Filter
Forward debug to port
501