Digi TransPort WR11 User Manual page 191

Configuring network interfaces
Command Instance
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
Digi TransPort® Routers User Guide
Parameter Values
mhome 0-255
igmp 0, 1
bridge 0, 1
heartbeatip IP address
hrtbeatint 0-86400
hbipent blank, eth, ppp
hbipadd 0-255
hbroute 0, 1
hbimsi 0, 1
Configure Ethernet interfaces
Equivalent web parameter
Multihome additional consecutive
addresses
Enable IGMP on this interface
Enable Bridge on this interface
Send Heartbeat messages to IP address
a.b.c.d every h hrs m mins s seconds
Send Heartbeat messages to IP address
a.b.c.d every h hrs m mins s seconds
This CLI value is entered in seconds only.
Use interface x,y for the source IP
address
x=Interface type
Use interface x,y for the source IP
address
y=interface number
Select the transmit interface using the
routing table
Include IMSI information in the
Heartbeat message
191