Digi TransPort WR11 User Manual page 327

Configuring network interfaces
Disable command echo
When enabled, disables command echo for the TransIP port. When disabled, all commands
issued are echoed back to the TransIP TCP socket.
Escape char c
The ASCII character to use as the escape character. The default character is +. Entering this
escape character three times followed by a pause of at least the Escape delay parameter and
an AT command causes the router to switch back to command mode from online mode. This is
equivalent to the S2 register setting.
Escape delay s milliseconds
The delay required between entering the escape sequence (default +++) and the AT command
for the router to drop back into command mode. This is equivalent to the S12 register setting.
3. Click Apply.
Command line
Command
transip
transip
transip
transip
transip
transip
transip
transip
Digi TransPort® Routers User Guide
Instance Parameter
n port
n host
n remport
n keepact
n staycon
n cmd_echo_
off
n escchar
n esctime
Equivalent web
Values parameter
Valid port number 0- Listen on port
65535
Valid IP address a.b.c.d Connect to IPaddress
or hostname a.b.c.d or Hostname
Valid port number 0- Port
65535
0-255 Send TCP Keep-Alives
every s seconds
on, off Enable Stay Connected
mode
on, off Disable command echo
Valid ASCII character Escape char c
0-255 Escape delay s
milliseconds
Configure serial interfaces
327