Digi TransPort WR11 User Manual page 526

Configuring Virtual Private Networking (VPN)
Accept incoming PPTP connections
When enabled, the router acts as a PPTP server and accepts incoming VPN connections.
Enable Server mode
When enabled, the router sends call_out call requests to the remote device. In the default
state which is unchecked, the router sends a call_in request to the remote device.
Enable Socket mode
When enabled, enables the use of a Digi proprietary mode whereby PPP packets are sent via
the PPTP control socket rather than in GRE packets.
Encrypt control data using SSL version n
When enabled, the router encrypts the control data using SSL. This is a Digi proprietary function
and is not part of standard PPTP. The drop-down list allows the SSL version to be selected. The
available options are:
Use default
n
TLSv1 only
n
SSLv2 only
n
Enable PPTP debug
Enables debug tracing.
3. Click Apply.
Command line
Command
pptp
pptp
pptp
pptp
pptp
pptp
pptp
pptp
pptp
Digi TransPort® Routers User Guide
Instance Parameter
0-9 name
0-9 remhost
0-9 ll_ent
0-9 ll_add
0-9 listen
0-9 swap_io
0-9 usesock
0-9 sslver
0-9 debug
Configure Point-to-Point Tunneling Protocol (PPTP)
Values
Up to 30 characters
Valid IP address a.b.c.d
Blank, PPP, ETH
Blank means Auto
0-4294967296
off, on
off, on
off, on
Blank,SSL,TLS1,SSL2
Blank is disabled
(default)
SSL means use default.
off, on
Equivalent web
parameter
Description
Remote Host a.b.c.d
Use Interface x,y
Use Interface x,y
Accept incoming PPTP
connections
Enable Server mode
Enable Socket mode
Encrypt control data
using SSL version n
Enable PPTP debug
526