Inspection Procedure: P14B2 - Hino Motors HINO 155 series Workshop Manual

2–786

INSPECTION PROCEDURE: P14B2

1
Check the DTC detected 1 (Engine ECU)
Has a DTC other than P14B2 been detected?
Go to the diagnostic procedure of a related
DTC.
2
Inspect the EGR valve connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
Connect the vehicle to HINO DX Ⅱ .
2.
3. Set the starter key to the "ON" position.
4. Select [Engine] and check if any DTC other than P14B2 has been
detected.
SHTS021270300710
YES
1. Check the connection of the EGR valve connector (looseness and
poor contact).
YES
NO
Go to step 2.
NO
Go to step 3.