3
Inspect the intake throttle valve position sensor 2 unit
VTA2
VC
E2
VC
E2
VTA2
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the intake throttle valve position sensor 2 connector.
3.
Use the electrical tester to measure the resistance between the
terminals of the intake throttle valve position sensor 2.
Starter key: LOCK
SHTS021270300332
YES
Measurement
Tester
conditions
connections
Intake throttle
valve position
sensor 2
(1) VC – VTA2
(2) VC – E2
(3) VTA2 – E2
Replace the intake throttle valve position
sensor 2.
Perform "After-inspection work" of INFOR-
MATION section.
2–371
Standard values
(1) 180
(2) 3 k
(3) 3 k
NO