Inspection Procedure: P0182 And P0183; Inspect The Fuel Temperature Sensor Connector; Inspect The Fuel Temperature Sensor - Hino Motors HINO 155 series Workshop Manual

2–308

INSPECTION PROCEDURE: P0182 and P0183

1

Inspect the fuel temperature sensor connector

Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
2

Inspect the fuel temperature sensor

Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the fuel temperature sen-
sor.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1. Check the connection of the fuel temperature sensor connector
(looseness and poor contact).
YES
1. Check the installation of the fuel temperature sensor.
2. Make sure there is no dirt, damage or clogging in the sensing unit
of the fuel temperature sensor.
YES
NO
Go to step 2.
NO
Go to step 3.