4
Check for short-circuit in wire harness of glow light
A
V7
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the signal check harness from the engine ECU. (Leave
the vehicle side engine ECU connector connected.)
3.
Disconnect the combination meter 40P connector.
4.
Use the electrical tester to measure the resistance between the
GIND (V7) terminal in the engine ECU (signal check harness) and
ground.
SHTS021270300428
Starter key: LOCK
YES
Measurement
Tester
conditions
connections
Engine ECU (sig-
nal check har-
ness)
GIND (V7) –
Ground
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–465
Standard values
NO