Hino Motors HINO 155 series Workshop Manual page 234

2–198
Check the operation of the VNT controller [HINO DX Ⅱ ]
3
Has DTC P00AF been detected?
Replace the VNT controller.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "ON" position.
Erase the trouble history using HINO DX Ⅱ .
2.
3. Set the starter key to the "OFF" position.
4. Set the starter key to the "ON" position again.
5. Select [Engine] and check if P00AF has been detected.
HINT
Turning the starter key "LOCK" and "ON" verifies the wiping oper-
ation of the VNT actuator (DC motor).
SHTS021270300183
Starter key: LOCK  ON
YES
Measurement conditions
NO
Procedure completed.
Perform "After-inspection work" of INFOR-
MATION section.