2–456
3
Inspect for short-circuit of the engine speed sub sensor (camshaft position sensor) harness
E54
D
E73
E53
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Connect the signal check harness to the engine ECU vehicle side
harness. (Do not connect the harness to the ECU.)
3.
Disconnect the engine speed sub sensor (camshaft position sen-
sor) connector.
4.
Use the electrical tester to measure the resistance between the
terminals of the engine ECU and ground.
SHTS021270300420
Starter key: LOCK
YES
Measurement
Tester
conditions
connections
Engine ECU (sig-
nal check har-
ness)
VCG (E53) –
Ground
G- (E54) – Ground
G+ (E73) – Ground
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
Standard values
NO