Inspection Procedure: P04Da - Hino Motors HINO 155 series Workshop Manual

INSPECTION PROCEDURE: P04DA

1
Check the response delay of the EGR valve
(2)
Do the measurements meet the standard value?
Go to step 2.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
(1)
Connect the vehicle to HINO DX Ⅱ .
2.
(3)
3. Set the starter key to the "ON" position.
(4)
4. Select [Inspection Menu] and then [EGR inspection] from the
(5)
menu, then inspect the response delay at the Target EGR position
and Actual EGR position.
! CAUTION
Perform the inspection while the engine is stopped to avoid dam-
ages.
SHTS021270300508
<Inspection procedure>
(1) Select [Inspection Menu].
(2) Select [EGR inspection].
(3) Select [Start inspection].
(4) Select [EGR opening UP]:
• Inspect the response delay at each step of the Target EGR position
and Actual EGR position from 0 to 90%.
(5) Select [EGR opening DOWN]:
• Inspect the response delay at each step of the Target EGR position
and Actual EGR position from 90 to 0%.
HINT
The EGR opening position changes of around 10% per step
between 0 – 90%.
From the Target EGR position to the Actual EGR position,
the response delay should be within 5 seconds.
YES
Standard values
NO
Replace the EGR valve.
Perform "After-inspection work" of INFOR-
MATION section.
2–555