Check Harness In Can Bus Line Between J/C_Hv1 And J/C Def Ssr - Hino Motors HINO 155 series Workshop Manual

2
Check harness in CAN bus line between J/C_HV1 and J/C DEF SSR (Failure Site 11)
Do the measurements meet the standard value?
Connect the J/C_HV1 connector, and go to
step 3.
ENGINE (J05E)/TROUBLESHOOTING
1. Disconnect the J/C_HV1 connector.
2. Use electrical tester to measure the resistance between No.4
(CANH) terminal and No.9 (CANL) terminal at the J/C_HV1 con-
nector.
Starter key: LOCK
SHTS021270300044
YES
Measurement Tester
conditions connections
J/C_HV1 connec-
tor
No.4 (CANH) –
No.9 (CANL)
CAN bus line disconnection between J/
C_HV1 and the J/C DEF SSR
Repair or replace the harness.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)
2–63
Standard values
110 – 130 
NO