Hino Motors HINO 155 series Workshop Manual page 507

6
Inspect the intake air temperature sensor (intake manifold) unit
E2 THA
Do the measurements meet the standard value?
Go to step 7.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
2. Disconnect the intake air temperature sensor (intake manifold)
connector.
3. Use the electrical tester to measure the resistance between the
terminals of the intake air temperature sensor (intake manifold).
SHTS021270300433
Starter key: LOCK
YES
Measurement Tester
conditions connections
Intake air tempera-
ture sensor (intake
manifold)
THA – E2
Replace the intake air temperature sensor
(intake manifold).
Perform "After-inspection work" of INFOR-
MATION section.
2–471
Standard values
20 C {68 F}:
7.336 – 5.794 k
50 C {122 F}:
2.435 – 1.994 k
NO