2–738
3
Inspect the PTO accelerator sensor unit
SIG
SIG
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the PTO accelerator sensor connector.
VCC
3.
Use the electrical tester to measure the resistance between the
terminals of the PTO accelerator sensor.
GND
SHTS021270300671
YES
Measurement
conditions
connections
PTO accelerator
sensor
Starter key: LOCK
SIG – VCC
SIG – GND
Replace the PTO accelerator sensor.
Perform "After-inspection work" of INFOR-
MATION section.
Tester
Standard values
More than 2
NO