5
Inspect for short-circuit of the exhaust brake magnetic valve harness
SOL-
Do the measurements meet the standard value?
Go to step 6.
6
Inspect disconnection of the exhaust brake magnetic valve harness
V4
SOL-
Do the measurements meet the standard value?
Go to step 7.
ENGINE (J05E)/TROUBLESHOOTING
1.
Disconnect the engine ECU connector.
2.
Use the electrical tester to measure the resistance between the
terminals of the exhaust brake magnetic valve vehicle side con-
nector and ground.
Starter key: LOCK
SHTS021270300504
YES
1.
Connect the signal check harness to the engine ECU.
2.
Use the electrical tester to measure the resistance between the
A
terminals of the exhaust brake magnetic valve vehicle side con-
nector and the engine ECU.
Starter key: LOCK
SHTS021270300505
YES
Measurement
Tester
conditions
connections
Exhaust brake
magnetic valve
vehicle side con-
nector
SOL- – Ground
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
Measurement
Tester
conditions
connections
Exhaust brake
magnetic valve
vehicle side con-
nector – Engine
ECU (signal check
harness)
SOL- – EXB(V4)
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–551
Standard values
NO
Standard values
1 or less
NO