5
Inspect for short-circuit in wire harness of intake air temperature sensor
E47
D
E58
Do the measurements meet the standard value?
Go to step 6.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Connect the signal check harness to the engine ECU vehicle side
harness. (Do not connect the harness to the ECU.)
3.
Use the electrical tester to measure the resistance between each
terminal in the engine ECU (signal check harness) and ground.
SHTS021270300211
Starter key: LOCK
YES
Measurement
Tester
conditions
connections
Engine ECU (sig-
nal check har-
ness)
THA (E47) –
Ground
E5 (E58) – Ground
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–233
Standard values
NO