2–566
INSPECTION PROCEDURE: P0500 and P0501
1
Inspect the combination meter
Was any failure found?
Check the combination meter (vehicle speed
signal system).
Perform "After-inspection work" of INFOR-
MATION section.
2
Check the DTC detected (vehicle control ECU)
Has DTC (P0500 or P0501) been detected?
Go to step 3.
ENGINE (J05E)/TROUBLESHOOTING
1.
Drive the vehicle and confirm that the combination meter (speed-
ometer) is working properly.
YES
1.
Set the starter key to the "LOCK" position.
Connect the vehicle to HINO DX Ⅱ .
2.
3.
Set the starter key to the "ON" position.
4.
Select [VCS] and check if the DTC (P0500 or P0501) has been
detected.
SHTS021270300517
YES
NO
Go to step 2.
NO
Go to step 5.