2–438
3
Inspect the engine speed main sensor (crankshaft position sensor) unit
NE-
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1.
2.
NE+
3.
SHTS021270300403
YES
Set the starter key to the "LOCK" position.
Disconnect the engine speed main sensor (crankshaft position
sensor) connector.
Use the electrical tester to measure the resistance between the
terminals of the engine speed main sensor (crankshaft position
sensor).
Measurement
conditions
connections
Engine speed
main sensor
Starter key: LOCK
(crankshaft posi-
tion sensor)
NE+ – NE-
Replace the engine speed main sensor
(crankshaft position sensor).
Perform "After-inspection work" of INFOR-
MATION section.
Tester
Standard values
20 C {68 F}:
108.5 – 142.5
NO