3
Inspect the intake throttle valve position sensor 1 unit
VTA
VC
VC
E2
VTA
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the connector of the intake throttle valve position sen-
sor 1 connector.
3.
Use the electrical tester to measure the resistance between the
terminals of the intake throttle valve position sensor 1 connector.
Starter key: LOCK
E2
SHTS021270300249
YES
Measurement
Tester
conditions
connections
Intake throttle
valve position
sensor 1
(1) VTA – VC
(2) VC – E2
(3) VTA – E2
Replace the intake throttle valve position
sensor 1.
Perform "After-inspection work" of INFOR-
MATION section.
2–271
Standard values
(1) 180
(2) 3 k
(3) 3 k
NO