Check The Dtc Detected 5 (Engine Ecu) - Hino Motors HINO 155 series Workshop Manual

2–398
12
Inspect the engine speed main sensor (Crankshaft position sensor)
Engine speed main sensor (Crankshaft position sensor)
Connector
Flywheel housing
Was any failure found?
Repair or replace the faulty parts.
Perform "After-inspection work" of INFOR-
MATION section.
13

Check the DTC detected 5 (engine ECU)

Have any DTCs (cylinder #1: P0263, #2: P0266, #3: P0269 and #4: P0272) been detected?
Inspect the crankshaft, connecting rods, fly-
wheel, and other parts of the drive system.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1. Inspect the condition of engine speed main sensor (crankshaft
position sensor) connector (looseness or poor contact).
2. Check the installation of the engine speed main sensor. (Crank-
shaft position sensor)
SHTS021270300359
YES
Perform an engine warm up. (engine coolant temperature: 80 C
1.
{176 F} or more)
2. Stop the engine.
3. Set the starter key to the "ON" position.
4. Select [Engine] and check if any followings DTCs (cylinder #1:
P0263, #2: P0266, #3: P0269 and #4: P0272) have been detected.
SHTS021270300360
YES
NO
Go to step 13.
NO
Procedure completed.
Perform "After-inspection work" of INFOR-
MATION section.