2–54
2
Check harness in CAN bus line between J/C_CAN_Diesel and J/C DEF SSR (Failure Site 10)
Do the measurements meet the standard value?
Connect the J/C_CAN_Diesel connector, and
go to step 3.
ENGINE (J05E)/TROUBLESHOOTING
1.
Disconnect the J/C_CAN_Diesel connector.
2.
Use electrical tester to measure the resistance between No.5
(CANH)
C_CAN_Diesel connector.
Starter key: LOCK
SHTS021270300033
YES
terminal
and
No.8
Measurement
Tester
conditions
connections
J/C_CAN_Diesel
connector
No.5 (CANH) –
No.8 (CANL)
CAN bus line disconnection between J/
C_CAN_Diesel and the J/C DEF SSR
Repair or replace the harness.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)
(CANL)
terminal
at
the
Standard values
110 – 130
NO
J/