INSPECTION PROCEDURE: P1133
1
Inspect the PTO accelerator sensor connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
2
Inspect the PTO accelerator sensor
Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the sensor.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Check the connection of the PTO accelerator sensor connector
(looseness and poor contact).
YES
1.
Check the installation of the PTO accelerator sensor.
2.
Make sure there is no dirt, damage or clogging in the sensing unit
of the PTO accelerator sensor.
YES
NO
Go to step 2.
NO
Go to step 3.
2–737