Inspection Procedure: P119F - Hino Motors HINO 155 series Workshop Manual

2–744

INSPECTION PROCEDURE: P119F

1
Check the DTC detected 1 (Engine ECU)
Has a DTC (P0192, P0193, P01A5, P01A6) other than P119F been detected?
Go to the diagnostic procedure of a related
DTC.
2
Inspect the common rail pressure sensor connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
Connect the vehicle to HINO DX Ⅱ .
2.
3. Set the starter key to the "ON" position.
4. Select [Engine] and check if any DTC other than P119F (for exam-
ple, P0192, P0193, P01A5, P01A6) have been detected.
SHTS021270300676
YES
1. Check the connection of the common rail pressure sensor connec-
tor (looseness and poor contact).
YES
NO
Go to step 2.
NO
Go to step 3.