4
Inspect the differential pressure sensor unit
VC
E2
PEX
E2
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the DPR differential pressure sensor connector.
3.
Use the electrical tester to measure the resistance between the
terminals of the differential pressure sensor.
Starter key: LOCK
SHTS021270300681
YES
Measurement
Tester
conditions
connections
Differential pres-
sure sensor
VC – E2
PEX – E2
Replace the differential pressure sensor.
Perform "After-inspection work" of INFOR-
MATION section.
2–751
Standard values
2 – 15 k
NO