2–20
Trouble diagnosis connector
ENGINE (J05E)/TROUBLESHOOTING
TROUBLE DIAGNOSIS USING THE COM-
PUTER (HINO DX Ⅱ )
PREPARATION FOR CONNECTING HINO DX Ⅱ
1.
(1)
Part name
DENSO DST-i Set
(Without LCD)
SHTS021270300023
DENSO DST-i Set
(With LCD)
HINT
Install the "Hino Diagnostic eXplorer Ⅱ " (HINO DX Ⅱ ) software in a
computer. For detailed installation procedures, refer to the HINO
DX Ⅱ OPERATION MANUAL supplied on the Global Service Portal
Site (Hino-GSPS).
CONNECTION OF HINO DX Ⅱ
2.
(1)
(2)
(3)
(4)
SHTS021270300024
The "HINO DX Ⅱ " is a failure diagnosis tool for the common
rail fuel injection system and the chassis system. For con-
necting the computer to a vehicle, the "DST-i" and the dedi-
cated cable will be required.
SPECIAL TOOL: Computer interface
Without Bluetooth 95171-01021
With Bluetooth 95171-01041
Without Bluetooth 95171-01031
With Bluetooth 95171-01051
Connect the DST-i to the trouble diagnosis connector located
in the electrical component box in the instrument panel or
located in the electrical component box behind the rearmost
seat.
Connect the computer in which the HINO DX Ⅱ is installed, to
the DST-i.
Turn the starter key to "ON".
Turn on the power switch of the computer to start the HINO
DX Ⅱ .
EN01H02127030602016007
Part No.