Check The Injector Fuel Injection Quantity (Hino Dx Ⅱ) - Hino Motors HINO 155 series Workshop Manual

Check the injector fuel injection quantity [HINO DX Ⅱ ]
2
NE Engine speed
@1,500 r/min (measurement by HINO-DX II)
Do the measurements meet the standard value?
Go to step 3.
ENGINE (J05E)/TROUBLESHOOTING
1. Start the engine.
2. Select [Injection quantity] from [Data monitor and Active test] in
HINO DX Ⅱ and measure the fuel injection quantity.
3. Select [Engine revolution] from [Data monitor and Active test] on
HINO DX Ⅱ , and measure the engine speed.
Engine revolution:
1,500 r/min (no load)
Engine coolant temperature:
80 C {176 F} minimum
SHTS021270300527
YES
Measurement conditions
Standard values
Type of
AT
Replace the injector.
Perform "After-inspection work" of INFOR-
MATION section.
2–577
Standard values
AT model:
3
12 mm /st maximum
3
Q (mm /st)
5.0q
NO