Hino Motors HINO 155 series Workshop Manual page 422

2–386
4
Inspect disconnection of the boost pressure sensor harness
C
PIM
E33
E
D
E77
E67
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1. Use the electrical tester to measure the resistance between the
terminals of the engine ECU (signal check harness) and the boost
pressure sensor vehicle side connector.
VC
Starter key: LOCK
SHTS021270300345
YES
Measurement Tester
conditions connections
Engine ECU (sig-
nal check har-
ness) – Boost
pressure sensor
vehicle side con-
nector
(1) VC2 (E33) – VC
(2) PIM (E67) – PIM
(3) E4 (E77) – E
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
Standard values
1 
NO