2–372
4
Inspect the intake throttle valve position sensor 2 power supply
E2
Do the measurements meet the standard value?
Go to step 5.
5
Inspect the intake throttle valve position sensor 2 signal circuit
E2
Do the measurements meet the standard value?
Go to step 8.
ENGINE (J05E)/TROUBLESHOOTING
1.
2.
VC
SHTS021270300333
YES
1.
VTA2
2.
SHTS021270300334
YES
Set the starter key to the "ON" position.
Use the electrical tester to measure the voltage between the termi-
nals of the intake throttle valve position sensor 2 vehicle side con-
nector.
Measurement
conditions
connections
Intake throttle
valve position
Starter key: ON
sensor 2 vehicle
side connector
VC – E2
Go to step 6.
Set the starter key to the "LOCK" position.
Use the electrical tester to measure the resistance between the
terminals of the intake throttle valve position sensor 2 vehicle side
connector.
Measurement
conditions
connections
Intake throttle
valve position
Starter key: LOCK
sensor 2 vehicle
side connector
VTA2 – E2
Go to step 6.
Tester
Standard values
4.5 – 5.5 V
NO
Tester
Standard values
25 – 35 k
NO