Check Harness In Can Bus Line Between J/C_Eng_Can2 / J/C_Eng_Can - Hino Motors HINO 155 series Workshop Manual

2–66
5
Check harness in CAN bus line between J/C_ENG_CAN2 and J/C_ENG_CAN (Failure Site 8)
K6W LEZ K6V
L4R
%J1 %J6 %J4
%J8
L48 KV9
KV8 LEV
%J5 %J2
%J3 %J7
Do the measurements meet the standard value?
Connect the J/C_ENG_CAN2 connector, and
go to step 6.
ENGINE (J05E)/TROUBLESHOOTING
1. Disconnect the J/C_ENG_CAN2 connector.
2. Use electrical tester to measure the resistance between No.5
(CANH)
C_ENG_CAN2 connector.
Starter key: LOCK
SHTS021270300047
YES
terminal and No.8
Measurement Tester
conditions connections
J/C_ENG_CAN2
connector
No.5 (CANH) –
No.8 (CANL)
CAN bus line disconnection between J/
C_ENG_CAN2 and the J/C_ENG_CAN
Repair or replace the harness.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)
(CANL) terminal at the
Standard values
110 – 130 
NO
J/