3
Check the neutral switch signal
A
V11
Do the measurements meet the standard value?
Replace the engine ECU.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Connect the signal check harness to the engine ECU.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the NSW
(V11) terminal in the engine ECU (signal check harness) and
ground.
SHTS021270300657
Starter key: ON
YES
Measurement
Tester
conditions
connections
Engine ECU (sig-
nal check har-
ness)
NSW (V11) –
Ground
Inspect the neutral switch circuit.
Perform "After-inspection work" of INFOR-
MATION section.
2–719
Standard values
Shift lever in N
range: ≥ 10 V
Shift lever in other
range: 0 V
NO