Inspect The Intercooler Outlet Temperature Sensor; Inspect The Intercooler Outlet Temperature Sensor Unit - Hino Motors HINO 155 series Workshop Manual

2–154
3

Inspect the intercooler outlet temperature sensor

Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the sensor.
Perform "After-inspection work" of INFOR-
MATION section.
4

Inspect the intercooler outlet temperature sensor unit

THG E2
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1. Check the installation of the intercooler outlet temperature sensor.
2. Make sure there is no dirt, damage or clogging in the sensing unit
of the intercooler outlet temperature sensor.
YES
1. Set the starter key to the "LOCK" position.
2. Disconnect the intercooler outlet temperature sensor connector.
3. Measure the resistance between the terminals of the intercooler
outlet temperature sensor using the electrical tester.
Starter key: LOCK
SHTS021270300141
YES
Go to step 4.
Measurement Tester
conditions connections
Intercooler outlet
temperature sen-
sor
THG – E2
Replace the intercooler outlet temperature
sensor.
Perform "After-inspection work" of INFOR-
MATION section.
NO
Standard values
20 C {68 F}:
7.336 – 5.794 k
50 C {122 F}:
2.435 – 1.994 k
NO