4
Inspect the power supply of the PTO accelerator sensor
VCC
GND
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the PTO accelerator sensor connector.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the PTO accelerator sensor vehicle side connector.
SHTS021270300624
Starter key: ON
YES
Measurement
Tester
conditions
connections
PTO accelerator
sensor vehicle
side connector
VCC – GND
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–681
Standard values
4.5 – 5.5 V
NO